HP ProCurve 420 Management And Configuration Manual page 109

Command Syntax
[no] filter ethernet-type protocol <protocol>
show filters
The following example shows how to set the native VLAN ID and enable VLAN
support. Note that to enable or disable VLAN support, you must reboot the
access point.
HP420(config)#native-vlanid 5
HP420(config)#vlan enable
Reboot system now? <y/n>:
The following example shows how to enable filtering for management access
and wireless-to-wireless communications.
HP420(config)#filter local-bridge
HP420(config)#filter ap-manage
HP420(config)#
The following example shows how to enable protocol filtering, preventing the
access point from forwarding Novell IPX frames.
HP420(config)#filter ethernet-type protocol novell-ipx(old)
HP420(config)#filter ethernet-type protocol novell-ipx(new)
HP420(config)#filter ethernet-type enable
HP420(config)#
The following example shows how to display the current filter status for the
access point.
Access Point Configuration
Setting up Filter Control
CLI Reference Page
page 6-58
page 6-59
5-51