HP ProCurve 420 Management And Configuration Manual page 96

Access Point Configuration
Configuring SNTP
5-38
The following example shows how to enable SNTP, configure primary and
secondary time server IP addresses, set the time zone, and enable Daylight
Saving.
HP420(config)#sntp-server enable
HP420(config)#sntp-server ip 1 10.1.0.19
HP420(config)#sntp-server ip 2 10.1.2.233
HP420(config)#sntp-server timezone -8
HP420(config)#sntp-server daylight-saving
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>: 31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>: 31
HP420(config)#
The following example shows how configure the access point's system clock
manually. Note that you must first disable SNTP to be able use the sntp-server
date-time command.
HP420(config)#no sntp-server enable
HP420(config)#sntp-server date-time
Enter Year<1970-2100>: 2003
Enter Month<1-12>: 8
Enter Day<1-31>: 9
Enter Hour<0-23>: 15
Enter Min<0-59>: 25
HP420(config)#
To display the current SNTP and clock settings from the Exec level, use the
show sntp command, as shown in the following example.
HP420#show sntp
SNTP Information
===========================================================
Service State
SNTP (server 1) IP
SNTP (server 2) IP
Current Time
Time Zone
Daylight Saving
===========================================================
HP420#
: Enabled
: 10.1.0.19
: 10.1.2.233
: 17 : 31, Aug 9th, 2003
: -8 (PACIFIC)
: Enabled, from Mar, 31th to Oct, 31th