HP ProCurve 420 Management And Configuration Manual page 74

Access Point Configuration
Configuring SNMP
5-16
SNMP management on the access point is enabled by default. To disable SNMP
management, type the following command:
HP420(config)#no snmp-server enable server
The following example shows how to enable SNMP, configure the community
strings, and set the location and contact parameters.
HP420(config)#snmp-server enable server
HP420(config)#snmp-server community alpha rw
HP420(config)#snmp-server community beta ro
HP420(config)#snmp-server location 2F-R19
HP420(config)#snmp-server contact Paul
HP420(config)#