Snmp Commands - HP ProCurve 420 Management And Configuration Manual

SNMP Commands

The access point includes an agent that supports Simple Network Manage­
ment Protocol (SNMP) versions 1, 2c, and 3. Access to the agent using SNMP
v1 and v2c is controlled by community strings. To communicate with the
access point, a management station must first submit a valid community string
for authentication.
Access to the access point using SNMP v3 provides additional security
features that cover message integrity, authentication, and encryption; as well
as controlling notifications that are sent to specified user targets.
Command Function
snmp-server Sets up the community access string to permit access GC
community to SNMP commands
snmp-server Sets the system contact string
contact
snmp-server Enables SNMP service and traps
enable server
snmp-server host Specifies the recipient of an SNMP notification
operation
snmp-server trap Enables specific SNMP notifications
snmp-server Sets the system location string
location
snmpv3 engine id Sets the engine ID for SNMP v3
snmpv3 user Sets the name of the SNMP v3 user
snmpv3 targets Configures SNMP v3 notification targets
snmpv3 filter Configures SNMP v3 notification filters
snmpv3 filter- Assigns SNMP v3 notification filters to targets
assignments
show snmpv3 Displays SNMP v3 user settings, targets, filters, and
filter assignments
show snmp-server Displays the status of SNMP communications
Command Line Reference

SNMP Commands

Mode Page
6-26
GC 6-27
GC 6-27
GC 6-28
GC 6-29
GC 6-31
GC 6-31
GC 6-32
GC 6-34
GC 6-35
GC 6-36
Exec 6-37
Exec 6-38
6-25