HP ProCurve 420 Management And Configuration Manual page 116

Access Point Configuration
Modifying Radio Settings
N o t e
5-58
Command Syntax
beacon-interval <interval>
dtim-period <interval>
fragmentation-length <length>
rts-threshold <threshold>
slot-time [short | long | auto]
preamble [long | shortorlong]
transmit-power <signal-strength>
max-association <count>
[no] shutdown
show interface wireless g
Using the CLI to Set the Country Code. The correct code must be set for
the country in which you operate the access point so that it uses the correct
authorized radio channels for wireless network devices.
The J8130A comes with the country pre-configured; the J8131A does not. The
radio is disabled if the Country Code is not set. Once the Country Code is set,
the radio can be enabled.
The following example shows how to set the Country Code for the access
point to United Kingdom (GB). You can display the available country codes
by using the country ? command. A full list of the access point's Country Codes
is provided in Table 6-1 on page 6-10.
CLI Reference Page
page 6-73
page 6-73
page 6-74
page 6-75
page 6-76
page 6-77
page 6-78
page 6-79
page 6-85
page 6-86