Transferring Configuration Files - HP ProCurve 420 Management And Configuration Manual

File Transfers

Transferring Configuration Files

A-10
Transferring Configuration Files
CLI Commands Used in This Section
Command Syntax
copy config <ftp | tftp>
copy <ftp | tftp> file
dir
reset <board | configuration>
Using the CLI commands described in this section, you can copy access point
configuration files to and from an FTP or TFTP server. Transferring configu­
ration files is not available using the web interface.
When you copy the access point configuration file to an FTP/TFTP server, that
file can later be downloaded to the access point to restore the system config­
uration. The success of the file transfer depends on the accessibility of the
FTP/TFTP server and the quality of the network connection.
The following example shows how to upload the configuration file to a TFTP
server.
HP420#copy config tftp
TFTP Source file name:syscfg
TFTP Server IP:192.168.1.19
HP420#
CLI Reference Page
page 6-40
page 6-40
page 6-42
page 6-6