HP V-M200 802.11n Access Point Quickstart This Quickstart shows you how to get started using the HP V-M200 Access Points (US J9467A, WW J9468A). After reading this Quickstart, you can visit www.hp.com/networking/support and download the HP V-M200 802.11n Access Point Management and Configuration Guide and other documentation.
Installation Important information to read before installing The V-M200 can be mounted on a wall, or placed on a desktop or any other suitable horizontal surface. The rubber feet prevent the V-M200 from sliding or scratching the surface. Prior to installing or using the V-M200, make sure that the installation plans are in...
83 mm (3.25 inches) apart. On the back of the V-M200, there is a hole- port of the PoE injector and the V-M200 to the data and power out port of the PoE drilling template with small arrows, indicating the correct spacing for the screw holes.
Page 4
IP configuration • DHCP server: The V-M200 will operate as a DHCP client and automatically obtain an IP address from a DHCP server on the network connected to the Ethernet port. If no DHCP server is found, the IP address 192.168.1.1 is assigned to the Ethernet and wireless ports.
Step 2: Specify wireless network settings • Pre-configure the DHCP server to assign a specific IP address to the V-M200. To do this you need to specify the V-M200 Ethernet MAC address and a reserved IP address on the DHCP server. The V-M200 Ethernet MAC address is printed on the V-M200 label identified as Ethernet MAC, and listed on the management tool Home page as Ethernet base MAC address.
Key: The V-M200 uses the key you specify in this field to generate the TKIP If using a PoE switch or injector, use an Ethernet cable to reconnect the V-M200 to the PoE switch or the data and power out port of the injector.