Command Line Reference
Authentication
6-52
mac-access permission
This command sets filtering to allow or deny listed MAC addresses.
Syntax
mac-access permission <allowed | denied>
•
allowed - Only MAC addresses entered as "active" in the address
filtering table are permitted access.
denied - MAC addresses entered as "active" in the address filtering
•
table are blocked.
Default
Denied
Command Mode
Global Configuration
Example
HP420(config)#mac-access permission denied
HP420(config)#
Related Commands
mac-access entry (page 6-52)
show authentication (page 6-54)
mac-access entry
This command enters or removes MAC address from the filter table.
Syntax
mac-access entry <mac-address> <active | inactive | deleted>
mac-address - Physical address of a client. Enter six pairs of hexa
•
decimal digits separated by hyphens, e.g., 00-90-D1-12-AB-89.
active - Adds the MAC address to the filter table as an active entry.
•
•
inactive - Adds the MAC address to the filter table as an inactive
entry.
deleted - Removes the MAC address entry from the filter table.
•
Default
None