Default Setting
1 Mbps for b-only and b+g modes
6 Mbps for g-only mode
Command Mode
Interface Configuration (Wireless)
Example
HP420(if-wireless g)#multicast-data-rate 2
HP420(if-wireless g)#
channel
This command configures the radio channel through which the access point
communicates with wireless clients.
Syntax
channel <channel | auto>
channel - Manually sets the radio channel used for communications
•
with wireless clients.
–
J8130A: The range is channels 1 to 11
–
J8131A: The range is channels 1 to 14 depending on the country
setting
•
auto - Automatically selects an unoccupied channel (if available).
Otherwise, the lowest channel is selected.
Default Setting
Automatic channel selection
Command Mode
Interface Configuration (Wireless)
Command Usage
•
The available channel settings are limited by local regulations, which
determine the number of channels that are available.
•
When multiple access points are deployed in the same area, be sure
to choose a channel separated by at least five channels to avoid having
the channels interfere with each other. You can deploy up to three
access points in the same area (e.g., channels 1, 6, 11).
Command Line Reference
Interface Commands
6-71