Port-2 interface context
Path: View > Enable > Config > Port-2 interface
This context provides commands for configuring Port-2.
end
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
end
Switches to parent context.
duplex
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
duplex (auto | half | full)
Sets the duplex mode on Port-2.
Parameters
Lets the AP automatically set duplex mode based on the type of equipment
auto
it is connected to.
Forces the port to operate in half duplex mode.
half
Forces the port to operate in full duplex mode.
full
speed
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
speed (auto | 10 | 100)
Sets the speed of Port-2.
Parameters
Lets the AP automatically set port speed based on the type of equipment it
auto
is connected to.
Forces the port to operate at 100 mbps.
100
Forces the port to operate at 10 mbps.
10
vlan
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
vlan <id>
Sets the default VLAN ID. Range: 1 - 4094. All outgoing traffic that does not have a VLAN already
assigned to it, is sent on this VLAN.
no vlan
Deletes the default VLAN ID.
CLI commands
2-41