HP ProCurve 420 Management And Configuration Manual page 247

The following example shows how to download new software to the access
point using a TFTP server.
HP420#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>:
TFTP Source file name:hp420-2038.bin
TFTP Server IP:10.1.0.9
Removing old runtime! Please wait a few minutes!
Creating file! Please wait a few minutes!
Firmware version of system is v2.0.29 and Updating Run-Time
code v2.0.38 NOW!
This firmware is compatible with hardware.
Updating Boot Line in NVRAM, please wait!
Warning! Updating firmware may cause configuration settings
to be incompatible.
(Suggestion:Using new default configuration settings lets
system be more
efficient,but system will lose current settings.)
Do you want to use NEW CONFIG SETTINGS? <y/n> [n]:n
HP420#dir
File Name
--------------------------
dflt-img.bin
hp420-2037.bin
syscfg
syscfg_bak
262144 byte(s) available
HP420#reset board
Reboot system now? <y/n>: y
When the access point finishes downloading the file from the server, a number
a messages are displayed as the software is installed before a prompt "Do you
want to use NEW CONFIG SETTINGS? <y/n> [n]:" appears.
Type "y" to reset the configuration to default values and reboot the access
point to activate the downloaded software. Type "n" to continue to use the
current configuration settings without rebooting.
Downloading Access Point Software
[1]:1
Type File Size
---- -- ---------
2 1325119
2 1325119
5 17004
5 17004
File Transfers
A-7