HP ProCurve 420 Management And Configuration Manual page 65

To set the SSID to "RD-AP#3" and display it, enter the CLI commands shown
in the following example.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless g)#ssid RD-AP#3
HP420(if-wireless g)#show
Wireless Interface Information
===========================================================
----------------Identification-----------------------------
Description
SSID
Radio mode
Channel
Status
----------------802.11 Parameters--------------------------
Transmit Power
Max Station Data Rate
Multicast Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
DTIM Interval
Preamble Length
Slot time
Maximum Association
----------------Security-----------------------------------
Closed System
802.11 Authentication
WPA clients
802.1x
Encryption
**[WEP key]***********************************************
Key Length
Default Transmit Key
Cipher
WEP Key Data Type
Static Keys :
Key 1: EMPTY Key 2: EMPTY
**[WPA key]***********************************************
WPA mode
Multicast cipher
Unicast cipher
Pre-shared Key Data Type
: Enterpris e 802.11g Access Point
: RD-AP#3
: 802.11b o nly
: 3
: Enabled
: FULL (18 dBm)
: 11Mbps
: 5.5Mbps
: 2346 bytes
: 2347 byte s
: 100 TUs
: 2 beacons
: LONG
: LONG
: 128 stati ons
: DISABLED
: OPEN
: SUPPORTED
: DISABLED
: DISABLED
: --------
: 1
: WEP
: Hexadecim al
Key 3: EMPTY
: Dynamic k ey
: WEP
: TKIP
: Hexadecimal
Access Point Configuration
Modifying System Information
Key 4: EMPTY
5-7