Snmpv3 User - HP ProCurve 420 Management And Configuration Manual

Command Line Reference
SNMP Commands
6-32
Command Usage
This command is used in conjuction with the snmpv3 user command.
•
• Entering this command invalidates the engine ID that is currently
configured.
• If the engine ID is deleted or changed, all SNMP users will be cleared.
You will need to reconfigure all existing users.
Example
HP420(config)#snmpv3 engine-id 1a:2b:3c:4d:00:ff
HP420(config)#

snmpv3 user

This command configures the SNMP v3 users that are allowed to manage the
access point. Use the no form to delete an SNMP v3 user.
Syntax
snmpv3 user
no snmpv3 user <user-name>
user-name - A user-defined string for the SNMP user. (32 characters
maximum)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Up to 10 SNMP v3 users can be configured on the access point.
• The SNMP engine ID is used to compute the authentication/privacy
digests from the pass phrase. You should therefore configure the
engine ID with the snmpv3 engine-id command before using this
configuration command.