HP ProCurve 420 Management And Configuration Manual page 142

Access Point Configuration
Configuring Wireless Security
5-84
The following example shows how to configure access point security for WPA­
PSK mode. Supported clients must be WPA-enabled and configured with the
same pre-shared key.
HP420(if-wireless g)#security-suite 3
HP420(if-wireless g)#wpa-preshared-key ASCII a very good
secret key
HP420(if-wireless g)#
Alternatively, you can use the following security-suite command to configure
WPA-PSK (AES) mode without using the wizard option:
HP420(if-wireless g)#security-suite open-system wpa­
required psk aes-aes
Using the CLI to Configure Dynamic WEP Keys. The following exam­
ple shows how to configure the access point to use dynamic WEP keys using
802.1X for authentication and key management. The security-suite command
wizard option 5 can be used to set the security parameters. The 802.1X
broadcast and session key refresh rates and a re-authentication timeout are
also set.
This example assumes that a RADIUS server is configured and available on
the wired network, it also assumes that the RADIUS server parameters are
configured on the access point.
HP420(if-wireless g)#security-suite 5
HP420(if-wireless g)#end
HP420(config)#802.1x broadcast-key-refresh-rate 5
HP420(config)#802.1x session-key-refresh-rate 5
HP420(config)#802.1x session-timeout 600
HP420(config)#
Alternatively, you can use the following security-suite command to configure
dynamic WEP encryption without using the wizard option:
HP420(if-wireless g)#security-suite open-system wpa­
disabled 802.1x-required