HP ProCurve 420 Management And Configuration Manual page 107

• Disable: Access point does not filter Ethernet protocol types.
• Enable: Access point filters Ethernet protocol types based on the
configuration of protocol types in the filter table. If a protocol has its
status set to "ON," the protocol is not passed by the access point.
To Enable VLAN Support:
1. Select the Security tab.
2. Click the [ Security Suite]
3. Select a security wizard option that employs 802.1X authentication, such
as Dynamic WEP (802.1x), WPA (AES-802.1x), or WPA (TKIP-802.1x). See "Web:
Using the Security Wizard" on page 5-74 for more details.
4. Click the
[Apply Changes]
Click the RADIUS Server link or [
5.
6. Configure parameters for the primary RADIUS server and, optionally, a
secondary RADIUS server. See "Web: Setting RADIUS Server Parameters"
on page 5-42 for more details.
7. Click the [Apply Changes]
8. Click the
[Filter Control]
9. Type a number between 1 and 4094 in the Native VLAN ID text field.
10. Set VLAN to enable.
11. Click the
[Apply Changes]
12. Reboot the access point.
To Set Local and Management Filters:
Select the Configuration tab.
1.
2. Click the [ Filter Control]
To prevent wireless-to-wireless client communication, set Local Bridge
3.
Filter to enable.
4. To prevent access point management from wireless clients, set AP
Management Filter to enable.
5. To implement specific Ethernet protocol filters, set Ethernet Type Filter to
enable.
a. From the list of protocol types, select ON for those protocols that you
want to filter from the access point.
6. Click the [Apply Changes]
button.
button.
Authentication Servers]
button.
button on the Configuration tab.
button.
button.
button.
Access Point Configuration
Setting up Filter Control
button.
5-49