HP ProCurve 420 Management And Configuration Manual page 92

Access Point Configuration
Enabling System Logging
5-34
The following example shows how to enable logging, set the minimum severity
level of messages to be logged, and send messages to the console.
HP420(config)#logging on
HP420(config)#logging level critical
HP420(config)#logging console
HP420(config)#
The following example shows how to configure the access point to send
logging messages to a Syslog server. The CLI also provides a command to
specify the facility type tag sent in Syslog messages. (See RFC 3164.) This type
has no effect on the kind of messages reported by the access point. However,
it may be used by the Syslog server to sort messages or to store messages in
the corresponding database.
HP420(config)#logging host 10.1.0.3
HP420(config)#logging facility-type 19
HP420(config)#
To display the current logging settings from the Exec level, use the show
logging command, as shown in the following example.
HP420#show logging
Logging Information
============================================
Syslog State
Logging Host State
Logging Console State
Server Domain name/IP
Logging Level
Logging Facility Type
=============================================
HP420#
: Enabled
: Enabled
: Enabled
: 10.1.0.3
: Error
: 19