Rotating the optional hot-swap rear hard disk drive cage up
To rotate the optional hot-swap hard disk drive cage up, complete the following
steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server top cover (see "Removing the server top cover" on page
4. Open the two respective blue latches on the chassis 1 .
5. Slowly rotate the rear hard disk drive cage outwards until it stops 2 .
6. Shift the switch on the rear hard disk drive cage to the lock position to keep the
Removing the PCI riser-card assembly
To remove the PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the server top cover (see "Removing the server top cover" on page
4. If you have the optional hot-swap rear hard disk drive cage installed, rotate it up
5. If an adapter is installed in the PCI riser-card assembly, disconnect any cables
6. Grasp the front and rear of the PCI riser-card assembly at the blue touch-points
46
System x3630 M4 Type 7158: Installation and User's Guide
on page 35.
external cables.
44).
hard disk drive cage fixed 3 .
on page 35.
all external cables.
44).
(see "Rotating the optional hot-swap rear hard disk drive cage up").
that are connected to the adapter
and lift it out of the PCI riser connector on the system board.