Removing A Pci Riser-Card Assembly - IBM System x3530 M4 Installation And Service Manual

10. Connect the power cord for the new power supply to the power-cord
11. Connect the other end of the power cord to a properly grounded electrical
12. Make sure that the ac power LED and the dc power LED on the power

Removing a PCI riser-card assembly

To remove a PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page Safety and "Installation
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Remove the server cover (see "Removing the server top cover" on page 362).
4. If an adapter is installed in the PCI riser-card assembly, disconnect any cables
5. Grasp the front and rear of the PCI riser-card assembly at the blue touch-points
328
System x3530 M4 Type 7160: Installation and Service Guide
7. Connect the power cables to the power supply.
8. Install the cover (see "Replacing the server top cover" on page 67).
9. Route the power cord through the cable retainer clip so that it does not
accidentally become disconnected.
connector on the power supply.
outlet.
supply are lit, indicating that the power supply is operating correctly.
guidelines" on page 30.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
that are connected to the adapter.
and lift it out of the PCI riser connector on the system board.