Replacing The Air Baffle - IBM NeXtScale nx360 M4 Installation And Service Manual

Replacing the air baffle

Use this information to install the air baffle.
To install the air baffle, complete the following steps:
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the compute node and peripheral devices and disconnect the power
3. Remove the cover (see "Removing the compute node cover" on page 110).
4. Align the air baffle pins with the baffle pin holes on the left hand side of the
Figure 27. Air baffle installation (compute node)
Figure 28. Air baffle installation (GPU tray)
5. Reinstall the cover (see "Installing the compute node cover" on page 111).
6. Slide the compute node into the rack.
7. Reconnect the power cords and any cables that you removed.
114
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
"Installation guidelines" on page 93.
cords and all external cables.
chassis for the left air baffle; then, lower the air baffles into the compute node.
Press the air baffles down until it is securely seated.
Note: Close the retaining clip on each end of the DIMM connector before
installing the air baffle for proper cooling.
Left air baffle
Right air baffle
Air baffle