Power Saving Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
The following parameter may be configured:
Parameter Description
Port LED State Click the radio buttons to enable or disable the port LED state.
Click Apply to save the settings.

Power Saving Settings

This window allows the user to implement the Switch's built-in power saving features and set the schedule to enforce the settings.
When the Power Saving Mode Link Detection State is Enabled, a port which has a link down status will be turned off to save
power to the Switch. This will not affect the port's capabilities when the port status is link up. When the Power Saving Mode
Length Detection State is Enabled, the Switch will automatically determine the length of the cable and adjust the power flow
accordingly. When Power Saving Mode LED State is Enabled, the LED's state of ports will be turned off during the configured
time range. When Power Saving Mode Port State is Enabled, the ports will be shut down during the configured time range. When
Power Saving Mode Hibernation State is Enabled, the Switch will go into a low power state and be idle during the configured
time range. It will shut down all the ports, all network function (telnet, ping, etc.) will not work, and only the console connection
will work via the RS232 port. If the Switch is an endpoint type PSE (Power Sourcing Equipment), it will not provide power to the
port.
To view the following window, click Configuration > Power Saving > Power Saving Settings:
The following parameter may be configured or viewed:
Parameter
Power Saving Mode
Link Detection State
Power Saving Mode
Length Detection
State
Power Saving Mode
LED State
Power Saving Mode
Figure 2 – 29. Port LED State Settings window
Figure 2 – 30. Power Saving Settings window
Description
Click the radio buttons to enable or disable the link detection state.
Click the radio buttons to enable or disable length detection state.
Click the radio buttons to enable or disable LED state.
Click the radio buttons to enable or disable port state.
24