Lldp; Lldp Global Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Click Apply to implement the changes made. Click Clear All to remove all the information entered. Click All to select all ports.

LLDP

LLDP

LLDP Global Settings

This window is used to configure the LLDP global settings.
To view the following window, click L2 Features > LLDP > LLDP > LLDP Global Settings:
The following parameters can be configured:
Parameter
LLDP State
LLDP Forward Message
Message TX Interval (5-
32768)
Message TX Hold
Multiplier (2-10)
LLDP Relnit Delay (1-
10)
LLDP TX Delay (1-8192)
LLDP Notification
Figure 3 - 73. LLDP Global Settings window
Description
Click the radio buttons to enable or disable the LLDP feature.
When LLDP is disabled, this function controls the LLDP packet forwarding message
based on individual ports. If LLDP is enabled on a port, it will flood the LLDP packet to all
ports that have the same port VLAN and will advertise to other stations attached to the
same IEEE 802 LAN.
This interval controls how often active ports retransmit advertisements to their neighbors.
To change the packet transmission interval, enter a value between 5 and 35768 seconds.
This function calculates the Time-to-Live for creating and transmitting the LLDP
advertisements to LLDP neighbors by changing the multiplier used by an LLDP Switch.
When the Time-to-Live for an advertisement expires the advertised data is then deleted
from the neighbor Switch's MIB.
The LLDP re-initialization delay interval is the minimum time that an LLDP port will wait
before reinitializing after receiving an LLDP disable command. To change the LLDP re-init
delay, enter a value between 1 and 10 seconds.
LLDP TX Delay allows the user to change the minimum time delay interval for any LLDP
port which will delay advertising any successive LLDP advertisements due to change in
the LLDP MIB content. To change the LLDP TX Delay, enter a value between 1 and 8192
seconds.
LLDP Notification Interval is used to send notifications to configured SNMP trap
103