Mld Snooping Rate Limit Settings; Mld Snooping Static Group Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Dynamic Router Port
Click the Select All button to select all the ports for configuration. Click the Clear All button to unselect all the ports for
configuration. Click the Apply button to accept the changes made. Click the <<Back button to discard the changes made and
return to the previous page.

MLD Snooping Rate Limit Settings

This window is used to configure the MLD snooping rate limit parameters.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Rate Limit
Settings:
The following parameters can be configured:
Parameter
Port List
VID List
Rate Limit (1-1000)
Click the Apply button to accept the changes made. Click the Find button to locate a specific entry based on the information
entered. Click the Edit button to re-configure the specific entry. Enter a page number and click the Go button to navigate to a
specific page when multiple pages exist.

MLD Snooping Static Group Settings

This window is used to view the Switch's MLD Snooping Group Table. MLD Snooping allows the Switch to read the Multicast
Group IP address and the corresponding MAC address from MLD packets that pass through the Switch.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Static Group
Settings:
enabled routers. This ensures that the forbidden router port will not propagate routing
packets out.
Displays router ports that have been dynamically configured.
Figure 3 - 40. MLD Snooping Rate Limit Settings window
Description
Enter the port list used for this configuration.
Enter the VID list used for this configuration.
Enter the MLD snooping rate limit used. By selecting the No Limit check box, the rate limit
for the entered port(s) will be ignored.
80