Access Profile List - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Action
Option
Ports
Click Apply to implement the changes made.
For more information about each of the parameters used in the ACL wizard, please see the detailed descriptions for each type of
ACL rule in the rest of this chapter.

Access Profile List

Access profiles allow you to establish criteria to determine whether the Switch will forward packets based on the information
contained in each packet's header.
The Switch supports four Profile Types, Ethernet ACL, IPv4 ACL, IPv6 ACL, and Packet Content ACL.
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch will
examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the Switch will use
to determine what to do with the frame. The entire process is described below in two parts.
Users can display the currently configured Access Profiles on the Switch.
To view the following window, click ACL > Access Profile List (one access profile of each type has been created for explanatory
purposes):
To add an entry to the Access Profile List window, click the Add ACL Profile button. To remove all access profiles from this
table, click Delete All.
this rule.
IPv6 – Selecting this option will allow the user to enter a range of IPv6 addresses for this rule.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that the packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the mirror port section. Port Mirroring must be enabled and a target port must be set.
After selecting the Permit action, the user can select one of the following options:
RX Rate – Enter the RX rate value.
Replace DSCP – Enter the DSCP value.
Replace ToS Precedence – Enter the ToS Precedence value.
Enter a port or range of ports.
Figure 7 - 2. Access Profile List window
201