Power Saving; Led State Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Console – If the IP address has the word Console next to it, it denotes a configuration upgrade
through the Console Serial Port (RS-232).
Telnet – If the IP address has the word Telnet next to it, it denotes a configuration upgrade
through Telnet.
SNMP – If the IP address has the word SNMP next to it, it denotes a configuration upgrade
through the Simple Network Management Protocol (SNMP).
WEB – If the IP address has the word WEB next to it, it denotes a configuration upgrade through
the web-based management interface.
SSH – If the IP address has the word SSH next to it, it denotes a configuration upgrade using
Secure Shell (SSH).
SIM – If the IP address has the word SIM next to it, it denotes a configuration upgrade through
the Single IP Management feature.
User States the user who downloaded the configuration. This field may read "Anonymous" or
"Unknown" for users that are not identified.
Boot Up States if the configuration will be used to boot up the Switch or not. Yes indicates that the
configuration will be used as the boot up configuration. No indicates that the configuration will not
be used as the boot up configuration.
Path Name This parameter is used to boot the Switch up from a configuration stored on an SD card.
(DGS-3200-24 To boot the Switch from a configuration stored on an SD card carry out the following:
model only)
Setting the Boot Up Configuration:
•
Click the Boot button next to the configuration you want to use as the Boot Up configuration.
•
A Success message appears to indicate that the configuration that will be used for booting up the Switch has changed.
•
The Boot Up parameter next to the configuration that will be used to boot up the Switch will read Yes.
Setting the Active Configuration:
•
Click the Active button next to the configuration you want to use as the Active configuration.
•
A Success message appears to indicate that the configuration that will be used as the active configuration has changed.
•
An asterisk will appear next to ID of the configuration that is being used as the active configuration.
Deleting a Configuration:
•
Click the Delete button next to the configuration you want to delete.
•
A Success message appears to indicate that the configuration has been deleted.

Power Saving

LED State Settings

This window is used to configure the port LED state.
To view the following window, click Configuration > Power Saving > LED State Settings:
•
Input the path of configuration on the SD-card (such as "c:\DGS3200.had").
•
Click the adjacent Set Boot button to use the configuration, stored on the SD-card, as
the bootup configuration.
•
Click the adjacent Active button to make the configuration, stored on the SD-card, the
active configuration.
23