D-Link xStack Reference Manual page 93

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Last Member Query Interval
(1-25)
Data Driven Group Expiry
Time (1-65535)
Querier State
Fast Done
State
Report Suppression
Data Driven Learning State
Data Driven Learning Aged
Out
Version
After setting the above parameters, click the Apply button in the top section of the window to allow your changes to be
implemented. Click the <<Back button to discard the changes made and return to the previous page.
Click the Modify Router Port
The following parameters can be configured:
Parameter
Static Router Port
Forbidden Router Port
This parameter is used to set the maximum amount of time between group-specific
query messages, including messages that have been sent in response to leave
group messages.
Specify the data driven group lifetime in seconds.
Choose Enabled from the drop-down menu to specify that the Switch should act as
an MLD Querier (sends MLD query packets). Choose Disabled from the drop-down
menu to specify that the Switch should act as a Non-Querier (does not send MLD
query packets).
Choose Enabled from the drop-down menu to enable the Fast Done function or
choose Disabled to disable. If it is enabled, the membership is immediately removed
when the system receive the MLD leave message.
Use the drop-down menu to specify if MLD Snooping should be Enabled or Disabled
from the specified VLAN.
Use the drop-down menu to enable or disable report suppression function. The
Switch uses MLD report suppression to forward only one MLD report per multicast
router query to multicast devices.
Use the drop-down menu to enable or disable the data driven learning of a MLD
snooping group.
Use the drop-down menu to enable or disable the aging on the entry.
Use the drop-down menu to specify the version of MLD packets that will be sent by
the specified ports. If an MLD packet received by the interface has a version higher
then the specified version, the packet will be dropped.
link to see the following window:
Figure 3 - 39. MLD Snooping Router Port Settings window
Description
This section is used to designate a range of ports as being connected to multicast-enabled
routers. This will ensure that all packets with such a router as its destination will reach the
multicast-enabled router regardless of the protocol.
This section is used to designate a range of ports as being not connected to multicast-
79