D-Link xStack Reference Manual page 239

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Parameter Description
Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100.
Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that match the access rule are not forwarded by the Switch
and will be filtered.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
Name configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Ports Ticking the All Ports check box will denote all ports on the Switch.
Click Apply to implement the changes.
To view the settings of a previously correctly configured rule, click the corresponding Show Details button on the CPU Access
Rule List window to view the following window:
To establish the rule for a previously created CPU Access Profile:
To configure the Access Rules for IP, open the CPU Access Profile List window and click Add/View Rules for an IPv6 entry.
This will open the following window.
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
Figure 7 - 37. CPU Access Rule Detail Information window for IPv4
Figure 7 - 38. CPU Access Rule List window for IPv6
225