D-Link xStack Reference Manual page 219

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
The window shown below is the Add ACL Profile window for IPv6:
The following parameters can be set for the IPv6 ACL type:
Parameter
Select Profile ID
Select ACL Type
IPv6 Class
Figure 7 - 6. Access Profile Detail Information window for IPv4
Figure 7 - 7. Add ACL Profile window for IPv6
Description
Use the drop-down menu to select a unique identifier number for this profile set. This value
can be set from 1 to 200.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content. This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet content in each frame's
header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
This class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
205