Telnet Settings; Password Encryption; Cli Paging Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide

Telnet Settings

Users can configure Telnet Settings on the Switch.
To view the following window, click Configuration > Telnet Settings:
The following parameters may be configured or viewed:
Parameter Description
Telnet Status
Telnet configuration is Enabled by default. If you do not want to allow configuration of the system
through Telnet choose Disabled.
Port (1-65535) The TCP port number used for Telnet management of the Switch. The "well-known" TCP port for
the Telnet protocol is 23.
Click Apply to set the Telnet setting.

Password Encryption

Users can configure Password Encryption on the Switch.
To view the following window, click Configuration > Password Encryption:
The following parameter may be configured or viewed:
Parameter
Password
Encryption Status
Click Apply to set the password encryption.

CLI Paging Settings

Users can stop the scrolling of multiple pages beyond the limits of the console when using the Command Line Interface.
To view the following window, click Configuration > CLI Paging Settings:
Figure 2 – 22. Telnet Settings window
Figure 2 – 23. Password Encryption window
Description
Password encryption is Disabled by default. To enable password encryption, click the
Enabled radio button.
Figure 2 – 24. CLI Paging Settings window
19