D-Link xStack Reference Manual page 228

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
The following parameters can be cconfigured:
Parameter Description
Access ID (1-
Type in a unique identifier number for this access. This value can be set from 1 to 200.
200)
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID
for the rule being created.
Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that match the access rule are not forwarded by the Switch and
will be filtered.
Select Mirror to specify that packets that match the access rule are mirrored to a port defined in the
config mirror port command. Port Mirroring must be enabled and a target port must be set.
Priority (0-7) Tick the corresponding check box if you want to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this command,
before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming
802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Replace Tick this check box to replace the Priority value in the adjacent field.
Priority
Replace DSCP
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the
(0-63)
selected criteria) with the value entered in the adjacent field.
Note: When an ACL rule is added to change both the priority and DSCP of an IPv4 packet, only
one of them can be modified due to a chip limitation. Currently the priority is changed when both
the priority and DSCP are set to be modified.
Chunk
This field will instruct the Switch to mask the packet header beginning with the offset value
specified.
RX Rate (1- Use this to limit RX bandwidth for the profile being configured. This rate is implemented using the
15625) following equation: 1 value = 64kbit/sec. (ex. If the user selects an RX rate of 10 then the ingress
Figure 7 - 21. Add Access Rule window for Packet Content
214