D-Link xStack Reference Manual page 225

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Replace Priority Tick this check box to replace the Priority value in the adjacent field.
Replace DSCP (0-
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the
63)
selected criteria) with the value entered in the adjacent field.
Note: When an ACL rule is added to change both the priority and DSCP of an IPv4 packet, only
one of them can be modified due to a chip limitation. Currently the priority is changed when both
the priority and DSCP are set to be modified.
VLAN Name
This field allows the user to enter a VLAN Name in the space provided, which will instruct the
Switch to examine the VLAN identifier of each packet header.
DSCP This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part of
the criterion for forwarding. The user may choose a value between 0 and 63.
RX Rate (1-15625) Use this to limit RX bandwidth for the profile being configured. This rate is implemented using the
following equation: 1 value = 64kbit/sec. (ex. If the user selects an RX rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1 and 15625 or tick the No Limit
check box. The default setting is No Limit.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
Name configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Counter Use the drop-down menu to specify if the Counter feature should be Enabled or Disabled.
Ports
When a range of ports is to be configured, the Auto Assign check box MUST be ticked in the
Access ID field of this window. If not, the user will be presented with an error message and the
access rule will not be configured. Ticking the All Ports check box will denote all ports on the
Switch.
Click Apply to implement the changes.
To view the settings of a previously correctly configured rule, click the corresponding Show Details button on the Access Rule
List window to view the following window:
To establish the rule for a previously created Access Profile:
To configure the Access Rules for IPv6, open the Access Profile List window and click Add/View Rules for an IPv6 entry. This
will open the following window:
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
Figure 7 - 16. Access Rule Detail Information window for IPv4
Figure 7 - 17. Access Rule List window for IPv6
211