802.1V Protocol Vlan Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
Click Add to make a new entry. Click Delete All to remove an entry. Click Delete Settings to remove the configuration from the
specific entry. Click Delte Group to remove the specific entry from the group.

802.1v Protocol VLAN Settings

Users can configure Protocol VLAN settings. The lower half of the table displays any previously created settings.
To view the following window, click L2 Features > VLAN > 802.1v Protocol VLAN > 802.1v Protocol VLAN Settings:
The following fields can be set:
Parameter
Group ID
Group Name
VID (1-4094)
VLAN Name
802.1p Priority
Port List
bit (2-octet) hex value. For IEEE802.3 LLC, this is the 2-octet IEEE 802.2 Link Service Access
Point (LSAP) pair. The first octet is for Destination Service Access Point (DSAP) and the
second octet is for Source.
Figure 3 - 9. 802.1v Protocol VLAN Settings window
Description
Highlight the corresponding RADIUS button to select a previously configured Group ID from
the drop-down menu.
Highlight the corresponding RADIUS button to select a previously configured Group Name
from the drop-down menu.
Highlight the RADIUS button to enter the VID. This is the VLAN ID that, along with the VLAN
Name, identifies the VLAN the user wishes to create.
Highlight the RADIUS button to enter a VLAN Name. This is the VLAN Name that, along with
the VLAN ID, identifies the VLAN the user wishes to create.
This parameter is specified if you want to re-write the 802.1p default priority previously set in
the Switch, which is used to determine the CoS queue to which packets are forwarded to.
Once this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously by the user.
Click the corresponding box if you want to set the 802.1p default priority of a packet to the
value entered in the Priority (0-7) field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
its incoming 802.1p user priority re-written to its original value before being forwarded by the
Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Select the specified ports you wish to configure by entering the port number in this field, or tick
the Select All Ports check box.
59