Port Error Disabled; Jumbo Frame Settings; Static Arp Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide

Port Error Disabled

The following window will display the information about ports that have had their connection status disabled, for reasons such as
storm control or link down status.
To view the following window, click Configuration > Port Configuration > Port Error Disabled:
The following parameters are displayed:
Parameter
Port
Port State
Connection Status
Reason

Jumbo Frame Settings

The Switch supports jumbo frames. Jumbo frames are Ethernet frames with more than 1,500 bytes of payload. The Switch
supports jumbo frames with a maximum frame size of 10240 bytes.
To view the following window, click Configuration > Port Configuration > Jumbo Frame Settings:
The following parameter can be configured:
Parameter Description
Jumbo Frame
This field will enable or disable the Jumbo Frame function on the Switch. The default is
Disabled. The maximum frame size is 10240 bytes.
To enable or disable Jumbo Frame, use the radio button and click Apply.

Static ARP Settings

The Address Resolution Protocol is a TCP/IP protocol that converts IP addresses into physical addresses. This table allows
network managers to view, define, modify, and delete ARP information for specific devices.
Static entries can be defined in the ARP table. When static entries are defined, a permanent entry is entered and is used to translate
IP addresses to MAC addresses.
To view the following window, click Configuration > Static ARP Settings:
Figure 2 - 9. Port Error Disabled window
Description
Displays the port that has been error disabled.
Describes the current running state of the port, whether enabled or disabled.
This field will read the uplink status of the individual ports, whether enabled or disabled.
Describes the reason why the port has been error-disabled, such as it has become a
shutdown port for storm control.
Figure 2 - 10. Jumbo Frame window
12