Assigning Bri Or Modem Interface To The Resource Pool; Activating The Interface - HP 7102dl - ProCurve Secure Router Configuration Manual

Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections
3-42
For example, you might enter:
ProCurve(config)# modem countrycode Germany
Enter modem countrycode ? for a complete list of keywords for countries.
The default setting is USA and Canada.

Assigning BRI or Modem Interface to the Resource Pool

To assign backup interfaces to the resource pool, enter the following com-
mand from the BRI or modem interface configuration mode context:
Syntax: resource pool-member <pool name> [<cost>]
Replace <pool name> with the name of the resource pool that this interface
will join.
Replace <cost> with a number between 1 and 255 to assign a priority to the
resource pool. The default setting is 1.
An interface can be a member of more than one resource pool. If an interface
belongs to two resource pools and is requested simultaneously by both, the
ProCurve Secure Router will use the cost option to determine which resource
pool can use the interface. If both resource pools are assigned the same cost,
the ProCurve Secure Router will use alphabetical order to determine which
resource pool can use the interface. That is, if the name of one resource pool
is Branch and the name of the other resource pool is Main, the router will
assign the interface to the Branch resource pool.
For example, to assign the BRI 1/3 interface to the resource pool named
"backup," enter:
ProCurve(config)# interface bri 1/3
ProCurve(config-bri 1/3)# resource pool-member backup
To remove an interface from a resource pool, enter the following command
from the interface configuration mode context:
Syntax: no resource pool-member <poolname>

Activating the Interface

The BRI and modem interfaces must be activated manually. From the interface
configuration mode context, enter:
Syntax: no shutdown