Wireless Distribution System (Wds) Problems And Solutions - Psion Teklogix 9160 G2 User Manual

Wireless gateway
Hide thumbs Also See for 9160 G2:
Table of Contents

Advertisement

This section provides information about how to solve common problems you might encoun-
ter in the course of updating network configurations on networks served by multiple,
clustered access points.
C.1

Wireless Distribution System (WDS) Problems And Solutions

If you are having trouble configuring a WDS link, be sure you have read the notes and cau-
tions in "Configuring WDS Settings" on page 206. These notes are reprinted here for your
convenience. The most common problem Administrators encounter with WDS setups is for-
getting to set both access points in the link to the same radio channel and IEEE 802.11
mode. That prerequisite, as well as others, is listed in the notes below.
Notes:
When using WDS, be sure to configure WDS settings on both access points partici-
pating in the WDS link.
You can have only one WDS link between any pair of access points. That is, a
remote MAC address may appear only once on the WDS page for a particular
access point.
Both access points participating in a WDS link must be on the same Radio channel
and using the same IEEE 802.11 mode. (See "Configuring Radio Settings" on
page 169 for information on configuring the Radio mode and channel.) For more
information on IEEE 802.11h, see "802.11h Regulatory Domain Control" on
page 148.
Ensure Spanning Tree Protocol (STP) is enabled to prevent endless loops and path
redundancy with either WDS bridges or combinations of Wired (Ethernet) connec-
tions and WDS bridges. If STP is enabled, you can use WDS to create backup links.
If STP is disabled, keep these rules in mind:
- Any two access points can be connected by only a single path; either a WDS
bridge (wireless) or an Ethernet connection (wired), but not both.
- Do not create "backup" links.
- If you can trace more than one path between any pair of APs going through
any combination of Ethernet or WDS links, you have a loop.
- You can only extend or bridge either the Internal or Guest network, but not
both.
Wireless Distribution System (WDS) Problems And Solutions
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Appendix C: Troubleshooting
C-43

Advertisement

Table of Contents
loading

Table of Contents