Table of Contents
Advertisement
STP
The Spanning Tree Protocol (STP) is an IEEE 802.1 standard protocol (related to network
management) for
MAC
loops in the network created by multiple active paths between client stations. Loops occur
when there are multiple routes between access points. STP creates a tree that spans all of the
switches in an extended network, forcing redundant paths into a standby or blocked state.
STP allows only one active path at a time between any two network devices (this prevents
the loops) but establishes the redundant links as a backup if the initial link should fail. If STP
costs change, or if one network segment in the STP becomes unreachable, the spanning tree
algorithm reconfigures the spanning tree topology and re-establishes the link by activating
the standby path. Without STP in place, it is possible that both connections may be
simultaneously live, which could result in an endless loop of traffic on the LAN
Subnet Mask
A Subnet Mask is a number that defines which part of an IP address is the network address
and which part is a host address on the network. It is shown in dotted-decimal notation (for
example, a 24-bit mask is shown as
(for example,
192.168.2.0/24
The subnet mask allows a router to quickly determine if an IP address is local or needs to be
forwarded by performing a bitwise AND operation on the mask and the IP address. For
example, if an IP address is
Network address is
192.168.2.0
The bitwise AND operator compares two bits and assigns 1 to the result only if both bits are
1. The following table shows the details of the netmask:
IP address
Netmask
Resulting network address
Supported Rate Set
The supported rate set defines the transmission rates that are available on this wireless
network. A station may be able to receive data at any of the rates listed in this set. All stations
must be able to receive data at the rates listed in the
bridges that manages path redundancy and prevents undesirable
255.255.255.0
).
and the netmask is
192.168.2.128
.
192.168.2.128
255.255.255.0
192.168.2.0
Psion Teklogix 9160 G2 Wireless Gateway User Manual
) or as a number appended to the IP address
255.255.255.0
11000000 10101000 00000010 10000000
11111111 11111111 11111111 00000000
11000000 10101000 00000010 00000000
Basic Rate
Set.
Appendix D: Glossary
STP
, the resulting
D-69
Advertisement
Table of Contents
