Table of Contents
Advertisement
Figure 20.3 Wireless Distribution System Settings
The following notes summarize some critical guidelines regarding WDS configuration.
Please read all the notes before proceeding with WDS configuration.
Note: When using WDS, be sure to configure WDS settings on both access points participat-
ing in the WDS link.
You can have only one WDS link between any pair of access points. That is, a remote
MAC address may appear only once on the WDS page for a particular access point.
Both access points participating in a WDS link must be on the same Radio channel
and using the same IEEE 802.11 mode. (See Chapter 16: "Configuring 802.11 Radio
Settings" for information on configuring the Radio mode and channel.)
When 802.11h is operational, setting up WDS links can be difficult. See "802.11h
Regulatory Domain Control" on page 148.
Chapter 20: Wireless Distribution System
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Configuring WDS Settings
207
Advertisement
Table of Contents
