Automatic Radio Address - Psion Teklogix 9160 G2 User Manual

Chapter 22: The 9160 G2 As Base Station
Radio Link Features Configuration Settings
Timeout is 60, and this parameter is set to 75%, then the timeout would be 60 min x 75% =
45 minutes.
An offline mobile computer is still considered part of the system. Messages to offline mobile
computers are queued at the 9160 G2. The mobile computer remains offline until it trans-
mits an online message. Values for this parameter range from 50 to 90.
Direct TCP Connections for TekTerm
Enabling this parameter allows the TekTerm program resident in Psion Teklogix mobile
computers to connect directly to the 9160 G2, when it is acting as a base station to a host via
TCP/IP.
Direct TCP Check Duplicate Terminal Number
When this parameter is enabled, the 9160 G2 will reject Direct TCP mobile computers
which try to connect using a terminal number already in use by another mobile computer.
When disabled, the most recent mobile computer to connect will take precedence over the
other mobile computers using the same terminal number.

22.4.3.2 Automatic Radio Address

Each Psion Teklogix mobile computer using the radio link has a unique radio address
number, which can be assigned automatically by the 9160 G2 by enabling this parameter.
To enable this parameter, the values for the first and last radio address numbers must lie
between 1 and 3840. The default values for the range are 1024 ... 2084. To disable the pa-
rameter, set the values to 0.
Notes: When enabling this parameter:
1. Direct TCP Connections for TekTerm must be disabled (see page 244).
2. The Auto ID parameter in the mobile computer must be enabled in order for
the radio address to be automatically assigned.
244 Psion Teklogix 9160 G2 Wireless Gateway User Manual