Table of Contents
Advertisement
Chapter 20: Wireless Distribution System
Updating Settings
The MAC address for MyAP1 (the access point you are currently viewing) will show as
the "Local Address" at the top of the page.
3. Configure a WDS interface for data exchange with MyAP2.
Start by entering the MAC address for MyAP2 as the "Remote Address" and fill in the
rest of the fields to specify the network (guest or internal), security, and so on. Save the
settings (click Update).
4. Navigate to the radio settings on the Administration Web pages (Manage > 802.11
Advanced Settings) to verify or set the mode and the radio channel on which you
want MyAP1 to broadcast.
Remember that the two access points participating in the link, MyAP1 and MyAP2,
must be set to the same Mode and be transmitting on the same channel.
For our example, let's say we're using IEEE 802.11b Mode and broadcasting on
Channel 6. (We'd choose Mode and Channel from the drop-down menus on the
Radio tab.)
5. Now repeat the same steps for MyAP2:
• Open Administration Web pages for MyAP2 by using MyAP2's IP address in
• Navigate to the WDS tab on MyAP2 Administration Web pages. (MyAP2's
• Configure a WDS interface for data exchange with MyAP1, starting with the
• Navigate to the radio settings for MyAP2 to verify that it is using the same mode
• Be sure to save the settings by clicking Update.
20.4
Updating Settings
To update WDS settings:
1. Navigate to the WDS tab page.
2. Configure the WDS settings as required.
3. Click the Update button to apply the changes.
210
Psion Teklogix 9160 G2 Wireless Gateway User Manual
a URL.
MAC address will show as the "Local Address".)
MAC address for MyAP1.
and broadcasting on the same channel as MyAP1. (For our example Mode is
802.11b and the channel is 6.)
Advertisement
Table of Contents
