Table of Contents
Advertisement
Chapter 3: PreLaunch Checklist
Default Settings For The 9160 G2 Wireless Gateway
Table 3.1 9160 G2 Default Settings
Option
Network Name
(SSID)
Network Time Proto-
col (NTP)
IP Address
Connection Type
Subnet Mask
28
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Default Settings
"TEKLOGIX" for the Internal interface
"TEKLOGIX Guest" for the Guest inter-
face
None
192.168.1.10
The default IP address is used if you do
not use a Dynamic Host Configuration
Protocol (DHCP) server. You can
assign a new static IP address through
the Administration Web pages.
If you have a
DHCP
server on the net-
work, then an IP address will be dynami-
cally assigned by the server at AP startup.
Dynamic Host Configuration Protocol
(DHCP)
If you do not have a
DHCP
server on the
Internal network and do not plan to use
one, the first thing you must do after bring-
ing up the access point is to change the
Connection Type from "DHCP" to
"Static IP".
The Guest network must have a DHCP
server.
None
This is determined by your network setup
and DHCP server configuration.
Related Information
"Review / Describe The Access Point" on page 48 in
"Configuring Basic Settings" on page 45
"Configuring "Internal" Wireless LAN Settings" on
page 150 in "Setting The Wireless Interface" on
page 145
"Configuring "Guest" Network Wireless Settings" on
page 151 in "Setting The Wireless Interface" on
page 145
"Network Time Protocol Server" on page 309
"Understanding Dynamic & Static IP Addressing On
The 9160 G2 Wireless Gateway" on page 32
"Understanding Dynamic & Static IP Addressing On
The 9160 G2 Wireless Gateway" on page 32
For information on how to re-configure the Connection
Type, see "Internal Interface Settings" on page 140.
"The Ethernet (Wired) Interface" on page 135
Advertisement
Table of Contents
