Update Settings - Psion Teklogix 9160 G2 User Manual

Chapter 11: Maintenance And Monitoring
Log Relay Host For Kernel Messages
Note: The syslog process will default to use port 514. We recommend keeping this default
port. However; If you choose to reconfigure the log port, make sure that the port num-
ber you assign to syslog is not being used by another process.
11.2.4.3 Enabling/Disabling The Log Relay Host On The Status, Events Page
To enable and configure Log Relaying on the Status > Events page, set the Log Relay
options as described below and then click Update.
Table 11.3 Log Relay Host Settings
Field
Relay Log
Relay Host
Relay Port

Update Settings

To apply your changes, click Update.
If you enabled the Log Relay Host, clicking Update will activate remote logging. The
access point will send its kernel messages real-time for display to the remote log server
monitor, a specified kernel log file, or other storage, depending on how you configured the
Log Relay Host.
If you disabled the Log Relay Host, clicking Update will disable remote logging.
126 Psion Teklogix 9160 G2 Wireless Gateway User Manual
Description
Choose to either enable or disable use of the Log Relay Host:
If you select the Relay Log checkbox, the Log Relay Host is enabled and the Relay Host and Relay Port fields
are editable.
Specify the IP Address or DNS name of the Relay Host.
Note: If you are using Devicescape Wireless Operations Center, the Repository Server should
receive the syslog messages from all access points. In this case, use the IP address of the
Operations Center Repository Server as the Relay Host.
Specify the Port number for the syslog process on the Relay Host.
The default port is 514.