Table of Contents
Advertisement
1. Configure the following settings on the Association tab on the Network Properties
dialog.
Table B.7 Association Settings
Network Authentication
Data Encryption
This key is provided for
me automatically
2. Configure these settings on the Authentication tab.
Table B.8 Authentication Settings
Enable IEEE 802.1x authentication for this network
EAP Type
3. Click Properties to bring up the Smart Card or other Certificate Properties dialog
and enable the Validate server certificate option.
Table B.9 Smart Card Or Other Certificate Properties Settings
Validate Server Certificate
Certificates
Click OK on all dialogs to close and save your changes.
4. To complete the client configuration you must now obtain a certificate from the
RADIUS server and install it on this client. For information on how to do this see
"Obtaining A TLS-EAP Certificate For A Client" on page B-35.
Connecting To The Wireless Network With An IEEE 802.1x Client Using A Certificate
IEEE 802.1x clients should now be able to connect to the access point using their TLS cer-
tificates. The certificate you installed is used when you connect, so you will not be prompted
for logon information. The certificate is automatically sent to the RADIUS server for au-
thentication and authorization.
Appendix B: Security Settings on Wireless Clients/RADIUS Server
Open
WEP
Note: An RC4 stream cipher is used to encrypt the frame body and cyclic redundancy
checking (CRC) of each IEEE 802.11 frame. This is the same encryption algorithm as
is used for Static WEP; therefore, the data encryption method configured on the client
for this mode is WEP.
Enable (click to check) this option.
Enable this option (click to check the box).
In the certificate list shown, select the certificate for this client.
Psion Teklogix 9160 G2 Wireless Gateway User Manual
IEEE 802.1x Client Using EAP/TLS Certificate
Enable (click to check) this option.
Choose Smart Card or other Certificate.
B-21
Advertisement
Table of Contents
