Table of Contents
Advertisement
Chapter 22: The 9160 G2 As Base Station
Radio Link Features Configuration Settings
22.4.3.1 Radio Link Features
Operate in Cellular Mode
To operate as a cellular base station, this parameter should be enabled.
Note: The 9500 Communications Server must also be set to cellular mode.
Poll ID
In Adaptive Polling/Contention protocol for narrow band radios, Poll ID is used to assign a
unique address to each base station. As the mobile computers move from one base station to
another, this address is transmitted by the base stations to the mobile computers, identifying
each 9160 G2 in a multiple base station system.
Polling Protocol Terminal Timeout
This parameter determines the time in minutes that a mobile computer can be inactive
before the 9160 G2 declares it offline. Before this happens, the mobile computer will be de-
clared offline by the Percent Polling Protocol Terminal Timeout parameter (see below).
After the mobile computer is removed from the system, it will need to re-initialize in order
to communicate with the 9160 G2. This parameter reduces the overhead on the radio link
caused when mobile computers which are not communicating are supported. The allowable
values range from 1 to 240.
Percent Polling Protocol Terminal Timeout
This parameter determines the time that a mobile computer is allowed to be inactive before
the 9160 G2 declares it offline. This time is expressed as a percentage of the Polling Proto-
col Terminal Timeout parameter (see above). For example, if the Polling Protocol Terminal
Psion Teklogix 9160 G2 Wireless Gateway User Manual
243
Advertisement
Table of Contents
