Table of Contents
Advertisement
Figure 4.1 Ethernet Connections Using DHCP
ETHERNET CONNECTIONS WHEN USING DHCP FOR INITIAL CONFIGURATION
LAN
Access Point
Figure 4.2 Ethernet Connections Using Static IP
ETHERNET CONNECTIONS WHEN USING STATIC IP FOR INITIAL CONFIGURATION
Crossover Cable
(or Ethernet cable if your AP
supports auto MDI and MDI-X)
Access Point
2. Connect the power adaptor to the power port on the back of the access point, and
then plug the other end of the power cord into a power outlet (preferably, via a surge
protector).
Chapter 4: Quick Steps For Setup And Launch
Connect The Access Point To Network And Power
HUB
Admin PC to Hub
Administrator Computer
(This PC must have an IP address on the
same subnet as Access Point.)
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Administrator Computer
39
Advertisement
Table of Contents
