Table of Contents
Advertisement
Chapter 4: Quick Steps For Setup And Launch
A Note About Setting Up Connections For A Guest Network
4.2.1
A Note About Setting Up Connections For A Guest Network
The 9160 G2 Wireless Gateway offers an out-of-the-box Guest Interface that allows you to
configure an access point for controlled guest access to the network. The same access point
can function as a bridge for two different wireless networks: a secure "Internal" LAN and a
public "Guest" network. This can be done virtually, by defining two different Virtual LANs
via the Administration UI.
For information on configuring Guest interface settings on the Administration UI, see
Chapter 14: "Setting Up Guest Access".
4.2.1.1 Hardware Connections For A Guest VLAN
If you plan to configure a guest network using VLANs, do the following:
•
Connect a network port on the access point to a VLAN-capable switch.
•
Define VLANs on that switch.
4.3
Power On The Access Point
The 9160 G2 Wireless Gateway powers on and initializes when you plug it in.
4.4
Log On To The Administration Web Pages
When you go to the IP address of the 9160 G2 Wireless Gateway Administration Web
pages, you are prompted for a user name and password.
The defaults for user name and password are as follows.
40
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Advertisement
Table of Contents
