Table of Contents
Advertisement
The following sections describe how to configure multiple wireless networks on Virtual
LANs (VLANs).
15.1
Navigating To Virtual Wireless Network Settings
To set up multiple networks on VLANs, navigate to the Manage > VWN tab, and update the
fields as described below.
Figure 15.1 VWN Settings
15.2
Configuring VLANs
Note: To configure additional networks on VLANs, you must first enable Virtual Wireless
Networks on the Ethernet Settings page. See "Virtual Wireless Networks" on
page 140.
Important: If you configure VLANs, you may lose connectivity to the access point. First,
be sure to verify that the switch and DHCP server you are using can support
VLANs per the IEEE 802.1Q standard. After configuring VLANs, physically
reconnect the Ethernet cable on the switch to the tagged packet (VLAN) port.
Then, re-connect via the Administration Web pages to the new IP address. (If
Navigating To Virtual Wireless Network Settings
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Chapter 15: Configuring VLANs
161
Advertisement
Table of Contents
