Table of Contents
Advertisement
Note: The following example assumes you are using the Built-in Authentication server that
comes with the 9160 G2 Wireless Gateway. If you are setting up EAP/PEAP on a cli-
ent of an AP that is using an external RADIUS server, the client configuration process
will differ somewhat from this example especially with regard to certificate validation.
If you configured the 9160 G2 Wireless Gateway to use WPA/WPA2 Enterprise (RADIUS)
security mode and to use either the Built-in Authentication Server or an external RADIUS
server that uses EAP/PEAP . . .
. . . first set up user accounts on the access point (go to User Management tab). . . .
. . . then configure WPA security with PEAP authentication on each client as follows.
Appendix B: Security Settings on Wireless Clients/RADIUS Server
WPA/WPA2 Enterprise (RADIUS) Client Using EAP/PEAP
Psion Teklogix 9160 G2 Wireless Gateway User Manual
B-23
Advertisement
Table of Contents
