For The Curious: More About Overlapping Channels; Example: A Network Before And After Channel Management - Psion Teklogix 9160 G2 User Manual

Wireless gateway
Hide thumbs Also See for 9160 G2:
Table of Contents

Advertisement

Chapter 8: Channel Management

For The Curious: More About Overlapping Channels

8.2.2

For The Curious: More About Overlapping Channels

The radio frequency (RF) broadcast
the radio on the access point uses for transmitting and receiving. The range of available
channels for an access point is determined by the
of the access point.
IEEE
802.11b/802.11g
while IEEE
52, 56, 60, 64, 149, 153, 157, 161, 165).
Interference can occur when multiple access points within range of each other are broadcast-
ing on the same or overlapping channels. The impact of this interference on network
performance can intensify during busy times when a large amount of data and media traffic
are competing for bandwidth.
The Channel Manager detects which bands (b/g or a) clustered APs are on, and uses a prede-
termined collection of channels that will not mutually interfere. For the "b/g" radio band, the
classical set of non-interfering channels is 1, 6, 11. Channels 1, 4, 8, 11 produce minimal
overlap. A similar set of non-interfering channels is used for the "a" radio band, which in-
cludes all channels for that mode since they are not overlapping.
8.2.3

Example: A Network Before And After Channel Management

Without automated channel management, channel assignments to clustered APs might be
made on consecutive channels, which would overlap and cause interference. For example,
AP1 could be assigned to channel 6, AP2 to channel 6, and AP3 to channel 5 as shown in
Figure 8.2.
Figure 8.2 Without Automatic Channel Management
Channel 6
(802.11b)
AP1
76
Psion Teklogix 9160 G2 Wireless Gateway User Manual
modes (802.11 b/g) support use of channels 1 through 11 inclusive,
802.11a
mode supports a larger set of non-consecutive channels (36, 40, 44, 48,
Channel 6
(802.11b)
AP2
Client Station
Channel
defines the portion of the radio spectrum that
IEEE 802.11
Channel 6
(802.11b)
Channel 5
(802.11b)
AP4
AP3
Client Station
mode (also referred to as band)
Interference from
APs on adjacent channels
(5,6,7)
Interference from APs
on same channel (6)
Channel 7
(802.11b)
AP5

Advertisement

Table of Contents
loading

Table of Contents