Creating Snmp Trap Community - ZyXEL Communications P-794H User Manual

The following table describes the labels in this screen.
Table 19 System > SNMP Community: Create
LABEL
Community
Write Access
IPaddress
Enabled
Wake Up
Enabled
OK
Reset
Return to
SNMP
Configuration

5.4.6 Creating SNMP Trap Community

Click System > SNMP, then click Create new Snmp Trap Community in the
Existing Snmp Trap Communities section to view the screen as shown. Use
this screen to configure a new SNMP trap community.
Figure 23 System > SNMP Trap Community: Create
P-794H User's Guide
DESCRIPTION
This field shows the community string, which act as a password for
requests from the management station.
Select true to allow the SNMP manager using this string to create or edit
MIBs (configure settings on the P-794H).
Select false to allow the SNMP manager using this string to collect
information from the P-794H.
Type the IP address of the remote SNMP management host in dotted
decimal notation, for example 192.168.1.1.
Select true to enable this SNMP community. Select false to disable it.
You can wake up the remote SNMP management host if you select true.
Otherwise, select false.
Click OK to save your changes.
Click Reset to restore your previously saved settings.
Click this if you want to return to the SNMP Config screen.
Chapter 5 System Settings
63