Table of Contents
Advertisement
Chapter 6 LAN Setup
Enter the configuration fields for your Ethernet route in the following screen and
click Apply to finish.
Figure 38 Ethernet Routed
The following table describes the fields in this screen.
Table 27 Ethernet Routed
LABEL
Description
Port
Use DHCP
LAN IP address
Mask
Apply
6.4 Create Virtual Interface
A Virtual Local Area Network (VLAN) divides a physical network into multiple
logical networks. The standard is defined in IEEE 802.1q.
You can create a virtual interface on routed interfaces in the LAN Configurations
screen. Click Virtual I/f next to an Ethernet route rule if you want to configure a
virtual interface.
76
DESCRIPTION
Enter a description for this route.
Select the port you are using for this route.
You can select if you want to use DHCP or enter the LAN IP address.
If you select Use DHCP, your P-794H can assign IP addresses, an IP
default gateway and DNS servers to Windows 95, Windows NT and
other systems that support the DHCP client.
If you select LAN IP address, the DHCP server will be disabled and
you must enter the LAN IP address and subnet mask.
Enter the LAN IP address for this route.
Enter the subnet mask for this route in dot decimal notation. The
subnet mask indicates what part of the IP address is the same for all
computers in the network.
Click this to save your changes.
P-794H User's Guide
Advertisement
Table of Contents
