Table of Contents
Advertisement
Chapter 5 System Settings
The following table describes the labels in this screen.
Table 20 System > SNMP Trap Community: Create
LABEL
Community
IPaddress
Port
Enable
Wake Up
Enabled
Version
OK
Reset
Return to
SNMP
Configuration
5.5 The Prompt Screen
In the Prompt screen, you can configure the prompt name which will be shown in
the CLI prompt and the host name in the Status screen.
Figure 24 System > Prompt
64
DESCRIPTION
This field shows the trap community string, which act as a password for
requests from the management station.
Enter the IP addresses of the manager to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
Select true to enable this SNMP trap community. Select false to disable
it.
You can wake up the remote SNMP management host if you select true.
Otherwise, select false.
Select the SNMP version for the P-794H. The SNMP version on the P-
794H must match the version on the SNMP manager. Choose SNMP
version 1 (v1) or version 2c (v2c).
Note: SNMP version 2c is backwards compatible with SNMP version
1.
Click OK to save your changes.
Click Reset to restore your previously saved settings.
Click this if you want to return to the SNMP Config screen.
P-794H User's Guide
Advertisement
Table of Contents
